VEHICODE 5009 RY10W 12093 LED Bulb Amber Yellow 12V/24V 7507 PY21W 12496 BAU15S Mini Turn Signal Light Replacement for Car Motorcycle Scooter Blinker Lamp (2 Pack)

Amazon says it doesn't work with my 2023 Triumph Scrambler 900 but the bulbs replace my turn signal lights just fine. In fact, you don't even have to install resisters to slow down the flash, you just need to know how to change the "Type" of flash on the bike (hold i button and turn key while still holding button, select mode by tapping i, hold i to confirm. Test your hazard lights button on the bike too, Type-4 did NOT function correctly.)These LEDs look great on the bike and they flash fine. You still do see a little amber from the bulbs through the stock plastic holding but I don't care. These bulbs are decently brighter than stock halogen bulbs and there should be no question which direction I want to turn. Thank you.

I have a 2022 KTM 1290 SAR and was having trouble with the stock front left turn signal bulbs. Figured I would try this to see if LED technology would be more stable and better overall. So far so good. Really bright light, fits perfect and will see if it lasts now. No errors were generated by using these bulbs. Overall I am very happy and it was a nice upgrade. I actually ordered another set for the rear.

As stated brighter than original bulb, but not being too bright.If noting just the "actual" bulb installation into the bulb socket, it's just a slight turn and it is locked in place. Could not be any easier.However, if noting the installation for a particular vehicle it depends on access to the socket. For me, it meant I had to lay on my back, reach up under the corner of the rear fascia turn socked, then remove old bulb, insert this LED and turn to lock. Then place socket with LED into hole and turn to lock assembly into place.For others, you might have to remove some bolts to remove a light assembly to get to the bulb, or remove some interior panels to access from inside. It all depends.Was it worth it? Yes, especially on vehicles like mine where the turn signal is in the rear fascia and you want something as bright and turns on instantly; better than having to wait till a bulb heats up. That heat up might take only a second, but that second a lot can happen. Granted, more important for brake lights than rear turn.NOTE: I did have to install a LED load resistor for each bulb. That can be quite a feat depending on access to wires and a metal location to mount the load resistor.

Very bright. Fast blinking but works well.

Looks great with the side LEDs reflecting in the housing + the forward facing LEDs for maximum visibility. No hyperflashing in a 2023 KTM street bike. Super bright - like really, really bright. Overall very pleased but ordered 2 sets and one came used, kinda disappointing but they seemed OK.

Working great for the turn signals on my Diavel Strada

Purchased 4 to replace the incandescent/filament indicator/turn signal bulbsfor a 2018 Triumph Tiger 800XCA.They fit and work perfectly, brighter and more noticeable than the originals, also the flash/blinker rate is perfect, no resistors or mods done.

I bough these for the front turn signals on my 2014 Kawasaki Ninja 1000. The stock bulbs were decent, but not great. These LEDS are much brighter! Even on a bright sunny day, they are significantly brighter than the original halogen bulbs. If you are looking for some LEDS to increase your visibility on a motorcycle, these are the ones to get.