Hibbent 10 Pieces Toilet Seat Bumpers, Universal Buffer Toilet Lid Rubber Bumpers Each One with 2 Thickness TPE Pads(2 Heights) Strong Adhesive Bidet Bumpers Used for Home, Hotel, Hospital

Bought to offset new bidet mount. Have held up well for about a month now. Perfect height & stay in place.

I followed the instructions and the adhesive is still holding after 3 months. Easy to install.

These are a heavy-duty answer to replacing the chusion pads that support a toilet seat. But the instructions leave a lot to be desired. First, they are typical instructions written by someone with little command of the English language. I've seen worse, but despite the good photos in the instructions, that did bother me.Second are the Primer "wipes" that are suppose to insure good adhesion. The envelope calls them "Primer: Adhesion promoter" There is a droplet graphic in the corner of the packet, with the note of "2.0ml" that suggests there is a damp towel inside. I opened two of them and there was no moisture whatsoever inside. I dutifully rubbed them on so I could say I tried.The kit comes with a few options to allow for different needed heights, and extra sticky tapes. The adhesive is very strong.Overall the kit is very good, except for the worthless Primer, and the poor instructions.

I have a funky toilet and a small bathroom. I use the seat to sit on to put my makeup on. When I sit on the lid at an angle the seat constantly moves. This has been a gamechanger for me. I was constantly having to use a special tool to remove the seat and put it back on. I haven't had any problems since using these!

I followed directions perfectly, then waited quite some time for adherence to bond even more. However, 1st time sitting on seat, 2 of the 4 bumpers slid off immediately into the toilet. Very dissatisfied.

I thought I had already reviewed this but seems not! Well, I'm very happy with this product. I have a wooden toilet seat, no paint, just dark wood. But the bumpers broke within a few months of use. So I replaced them with ones made for wooden seats, and again, within 2 months they were cracking and not doing the job. I was hesitant to try these, I didn't think they would stick to my wooden seat. But I was wrong! I used two per side, rather than the one that is suppose to be used, and positioned them a little behind and a little in front of the existing, broken bumpers. And they do sit a bit higher than the old ones did. But you don't notice it when you sit on the seat, and they WORK PERFECTLY! I was surprised with the pre-wipe the supply, as it was dry... I actually opened a second pack, thinking the first one was dried out. When I realized both were dry, I simply used it to wipe the pre-cleaned seat area where I intended to place the bumpers, and then placed them, closed the seat and at on it to set the bumpers. And they stuck perfectly! This was about a month ago, and absolutely NO sign of slipping or cracking! VERY happy with these bumpers, they truly are universal as they even work on wooden seats! Two thumbs up from me!

The adhesive sticks to the toilet seat but not to the risers themselves. When you sit, if you twist at all they will fall off. Super unsafe. Now I have to figure out how to get the gunk off from under my seat. Not worth your money.

Why did you pick this product vs others?:Flexibility. Two different heights, tough to measure what you need.