LucaSng Tilt/Trim Sender Limit Kit Fits Stern Drive MC-I, R, MR, Alpha One, Bravo Replaces Mercruiser 805320A03 805129A3 805130A2 18-7633

Product is good quality. My trim up switch quit working and had to use the trailer button to trim the outdrive up. This new trim limit switch fixed that problem, and the trim sender fixed the trim gauge not working.

Good fit calibrated well

Great price, easy to install, works great.

Couldn't beat the price, I was a bit nervous.But the things appeared to be nice and fit perfectly.I don't know how well they work just yet.Seems to be a great value.

So if your unfortunate like me, you have the 2 bold system that holds the wires in. Well that isn't so possible to remove without removing the lower or whatever it's called. I just rotated the part that goes in 180 degrees and bolted the sensor in backwards.I'll secure the wires better later with some sticky stuff, so I'm not making holes in the boat.

Got these because the wiring on my OEM trim senders was too corroded to repair. After a couple hours of swapping both sides out with this kit, I did a quick test which seemed fine and then put my boat away until it was time to take it out again. Once I got my boat in the water again, got the trim down, and got going the trim gauge began swinging erratically whenever I’d go to adjust the trim. Just like someone else mentioned, the rheostats inside the senders must not be set right or something. Unfortunately I did not keep my OEM ones, which I’m now kicking myself in the ass for. Definitely keep your old ones if the internals are ok and replace the rheostats in these aftermarket senders with your OEM ones. I just get to deal with it now until I decide to replace them again.Also, my trim up switch only works sometimes now after installing these. I can use the trailer button to trim up but it’s just one more thing that seems to be wrong with using this kit. All in all, I can get by with it, but this is definitely no where near the quality of OEM.

I've even installed a Faria trim gauge and the brown/white wire from the sender works great.

Worked perfectly, on one outing. The indicator hasn’t worked since. I’ve traced the wires, have cleaned the grounds, I have cleaned and reconnected the connectors have rotated the device. I have tried everything.

You have to do the maintenance on your boat

Exactly as described

Installed and trim sender didn't work. Could not adjust. No indication from full down to about one third up.Then needle is very jumpy. Waste of time and money. Can't return now. I will bite the bullet and go with OEM whenever I decide I really need a trim gauge and want to pay that ridiculous amount of money Mercury is charging.

This will b install on my doral citation boat ,Was delivered on time, well package, look to b good product, all parts seam to b thereWill give u updat once all installed,,

Changing these sending units is not a job for the faint of heart. Miserable at best. The sending units are easy to adjust but be sure you have a gauge that works first off. Another thing is that the wires are very flimsy so recommended putting some sort of protection on them outside the boat.Overall seems to work okay and the price was reasonable.