Do you sell the replacement inserts?

Hello dear customer, very glad to tell you that we started selling original blades, this is the product link: https://www.amazon.com/dp/B087BDMCZ4 Any questions, please feel free to contact us. NITOMAK Shop

Depth of cut, Inches per minute, chip load to place this cutter into the database Binstak can you provide information besides the rpm is a max. 16000

I had great luck with this cutter on my home made slab flattening sled. The toughest part was sanding after flattening, so be patient while cutting, and sanding will be easier. I recommend cutting one direction only, 1/64” to 1/32” deep, and not more than about 1/4 to 1/3 of the cutter diameter per pass. More than those will leave the grain “pulled” in different different directions, especially if you’re cutting hardwood end grain. Patience on cutting will save a ton of sanding. Plus, too much rough sanding also can spoil the flatness. Finally, it makes one hell of a mess! Best outdoors, with a vacuum hose jigged immediately in front of the cutter to catch the bulk of the sawdust jetting out ahead of the cutter. Patience! Less is more!

Do you have 1 1/4 diameter?

Dear customer, sorry, we don't have. we sell 1" , 2" and 3" diameter bit.

Does this come with the cutter heads?

Dear customer, it comes with 1 set initial insert blades. We sell original inserts and screws. The parameter of insert is 12mm*12mm*1.5mm, 35 degree, straight hole. The type of screw is M4-6. Inserts link: https://www.amazon.com/dp/B087BDMCZ4 Screws link: https://www.amazon.com/dp/B08VN25YZV You also can refer to this parameter to buy accessories from other places. Any further question, please feel free to contact us. NITOMAK and BINSTAK Cutomer Services Team

Surfacing Router Bit

التفاصيل

الوصف

الأسئلة الشائعة