Outdoor Dimmer for String Lights 1500W, IP67 Waterproof/150FT Range/Timer Control/3 Prong Outlet for Outdoor LED String Lights & Incandescent Bulbs, Wireless RF Remote Plug-in Dimmer Switch

We added 100ft of outdoor string lights we purchased from Amazon, lights themselves where great, bright with dimmable bulbs. However the lights simply turned on and off by plugging & unplugging from the socket. Added this outdoor dimmer switch, completely changed the use of the string lights. Remote on & off, when sitting at night relaxing we set the string lights to 5% brightness, very peaceful and relaxing. Company comes over we set between 60-80% brightness. Working on the deck at night 100%. Nice timer function, set the timer to 30 minutes and the lights go out. Really as made the lights more usable.Remote is radio frequency, old fashioned but works great, does not interfere with other devices and we don’t need are smart devices on the deck, I will repeat, you don’t need you smart device, escape and relax on the deck.Check your string lights are dimmable and if they are you should buy this.

I used it to dim the lights on a new Balsam Hill 7.5" Norwegian Spruce Christmas Tree. Just took the tree down. It was up since early Dec. When it was new and I noticed the LED lights I had ordered for it were very very bright, so bright that they would overwhelm everything else about the tree. I had choices, but I ordered the white LEDs because they are supposed to last much longer, more durable to hard knocks, and uses less current. I was very happy with the tree but wished I could tone the light down a little. I got this device within a couple days and we all liked it. One can adjust anywhere from around 20% to 100% or any thing in-between (in steps of 10%). We have found this so easy, it comes with 2 RF remote controls that you don't even have to be in the same room to operate the tree lighting. At night, when we have artificial room lighting, the tree looks best at about 60%. I have seen some very sunny days when the room. gets a lot of sunlight, it looks better turned up higher, maybe even up to 100%. These new LED Xp-mass are great but a little bright sometimes, this is just what you need to take the power down a little. Works just like they say and doesn't cost too much. When I use the Greek letter Chi (prefer to add the Rho) lest some think it's the pejorative letter X of our Latin alphabet, always a very strong negative meaning.

I bought this to use with outdoor LED string lighting and set up was super confusing. In the end we discovered because the current draw is so low, we simply added a nightlight on the second plug of the wall outlet. I've spoken to electricians who agree there is no good reason for this to occur but that "LED lighting is funny". So, if you're having trouble....put a load on the other outlet.

TL:DR - 2 units, both with the same issue..... Remote / dimming functions stop working, seemingly incompatible with a load of ~100W or less.Connected this to an LED outdoor string light set consisting of 48 -1W LED bulbs.Out of the box I noted even at 10% brightness, the bulbs were still fairly bright. Not a huge deal, I know dimmability of LED lights can vary but worth noting. Otherwise all was well for about 2 weeks, when the remote stopped working. For the next 3 days I could unplug the unit and reconnect to regain control for a short time.Afterward though, no reset would help. Power on, lights came on at 100%, no adjustments.Tried both remotes, tried new batteries, no luck. Blue light on the remotes show working, but no change.So I bought a second one, thinking the first was just defective, hey it happens.... Second one comes in, this one works for all of 30 minutes, starts doing the same thing! For now a reset gets the remotes working but I know where this is going...Then it dawned on me, this thing is rated up to 1000W, what if the ~50W load I have on it is simply too light and the system can't recognize enough is connected to properly regulate the dimmer. (Most likely a Triac circuit). It's very possible that I lucked out with the first one based on internal tolerances, but likely changes in weather / heat brought the load down just enough to lock it up.I grabbed an old halogen (250W) bulb and plugged it up to the dimmer circuit.... Eureka... System works perfectly. Disconnect, reconnect LED string, works for 10 minutes, dimmer functions stop.Tried both old and new dimmer system, swapping back and forth between each as well as between LED string set and 250W halogen... Same exact result every single time. 250W good, 50W LED bad. I did experiment with a few other bulbs and the threshold APPEARS to be right around 100W.... 40W plus ~50W LED string, controls stop. 60W or above plus ~50W LED string, works flawlessly.So for 2 nights I have ran the dimmer with both the LEDs and the 60W bulb, no issues at all. Hypothesis confirmed, but in the end, I don't want to have to add an incandescent or halogen bulb to get this thing to work, and adding another 50 LED lights to this will just be too much. So back they both go to Amazon.For those looking at this for 100+ LED bulbs or for just about any level of incandescent or halogen (up to 1000W of course), you will PROBABLY be ok. But for those with a moderate to small LED string setup, I recommend looking elsewhere.

As easy to connect as plugging in the light. It makes turning on and off your outdoor lights so easy! I love the way it dims. I just wish it can be done gradually with the increase or decrease rather than the preset percentages. Other than off, it can only lower to 10%. I love that this comes with 2 controls! I keep one upstairs near the balcony and one downstairs for the patio.The lights I went with are: Mlambert 2-Pack 48FT LED Dimmable String Lights Outdoor for Patio, Commercial Grade LED Edison Bulb String Lights Waterproof, LED Cafe Lights Bistro Lights Shatterproof for Pergola Deck Backyard(Total 96FT)

This controller/dimmer works great. We originally bought it for the party lights strung up at my daughter's wedding, about eight strands together I think. We then hung some of the lights up over our pool. The control/dimmer unit has been outside in weather extremes for two years...blizzards and up to 100 degree heat and it still works great.

I only had this for a few hours. set up is simple and the remote works with more features like blinking and timing etc. than I expected. Most importantly I want to be able to dim l e d rope lighting which lite up the yard like a runway. It has 10 preset dimness buttons and up and down arrows if your fuzzy about it. I works perfectly. I have mine set up on a timer but this remote can override the timer and I can turn it off before if I want. The description of the product in the enlargement photos indicated that it came with two remotes. I only got one but I think I got an upgraded remote. I works really well. I see some other reviews were having trouble with the remotes I guess time will tell. My only concern is it you don't have a working remote then then you got nothing that works. I'm going to contact the seller about getting that free extra remote. just in case. So far so good. says it has a 1 year warranty.

Awesome

Recieved this dimmer for my patio lights under gazeebo in Oct 2021 used 2 or 3 times to verify working was OK. Have just started to use gazeebo this month June 2022. Remotes Will not work, lights come on but do not turn off or adjust, changed batteries still not working. Unpacked second remote but it does not work either. Unit seems to get very hot did not feel that way when first used 8 months ago. Absolute waste of money very disappointed that a product would quit working after being used 3 times. Is mounted in dry location and power to unit is nturned off when not in use. Do not waste your money as this is not a cheap item either.