📡 Tune In, Stand Out! Your Signal Deserves the Best.
The Balun One Nine v2 is a compact and cost-effective 9:1 HF antenna balun designed for long wire and dipole antennas. It offers improved performance over its predecessor, featuring lower insertion loss and an expanded lower frequency limit. With three terminal block adapters for various wire configurations and excellent ESD protection, this balun is perfect for enthusiasts of Software Defined Radio (SDR) and ham radio. Made in North America and backed by a 1-year warranty, it's a reliable choice for your radio setup.
T**D
Works As Advertised ! Excellent !!
Using with SDRplay RSP1, that was given to me by a friend. I was skeptical at first of the One Nine and was pondering a quick return to vendor due to no case. I rigged an old RX bottle to house the OneNine that works. Upon set up and use for 10 days and nights on all Bands in all conditions I was intrigued . I had a Ham friend stop by with an Antenna Analyzer and we hooked it all up to my 50 foot end fed long wire antenna that's about 30 feet off the ground and It resonated extremely well on all Bands, 10m-40m and shortwave as well. We tried it without the ground as some thought it's not needed for receive only, Trust me the Ground made a Huge improvement in reception and lowered the noise level. All in All, very satisfied with this product for my particular setup and region.
D**Y
Does a great job at an affordable price.
I purchased this balun and constructed a 40m horizontal dipole antenna, and I cannot say a single bad thing about it. Does its job like it should and a great price. Only thing I wish was different is it would be cool if it either came with an enclosure or nooelec offered one for it. But hey nothing a little ingenuity can't take care of.
P**D
it's perfect item like described,
I received this item on time, easy installation, really matches perfect with my long wire antenna, improve every thing in my SDR device, nooelect so good item this is. I recommend to every one this item. low noise reception too. and the must important the quality product great.
R**M
A
A
C**1
Nice unit. GREAT support. Note: the unun functionality of Version 2 is different than Version 1
I bought one of these to match an old shortwave receiver of mine to a "random wire" antenna, expecting it to have the ability to be configured as an auto-transformer the same way that V1 could be. The unit I purchased could not be set up that way - the RF transformer on the board is different. (The RF transformer does not have a center tap the way the V1 transformer did.) That said, you can probably use this to match a balanced and unbalanced line, which my testing seemed to confirm - it just isn't the "typical" autotransformer unun setup that is typically used.When I brought this to the attention of Nooelec, they took a bit of time to research it and get back to me - but they DID research it, which impressed me, and decided to refund my purchase (which was way above and beyond, and not necessary, but much appreciated nonetheless.
M**H
SHORT WAVE!!!
I ran a length of magnet wire off of this and my shortwave reception SKYROCKETED..
E**C
1st had a badly soldered SMA connector. 2nd Works fine multiple emails asking for reviews is not ok.
1st one had a badly soldered SMA connector but the replacement was fine.Bugged twice now via email to leave a review so here I am leaving my honest opinion. Please DO NOT send multiple emails asking for reviews. Once is enough asking again is annoying and will upset customers.
P**S
Worked really well with Long wire and broomstick antennas
Worked really well with Long wire and broomstick antennas. Used it to feed a long run of low loss coax.
ترست بايلوت
منذ يوم واحد
منذ أسبوعين
