Tail Light Sequencer Kit - compatible with 1996-2004 Mustangs

This product worked Great !!!!!!! Had a question and support was on it !!!!

This works PERFECT on my 1998 Ford Mustang.....very easy to install just have to look up for an installation video and ready....I asked the seller for some information related, and their respond was easy and clear......besides price is much lower compared with similar products.....I truly recommend it if you are looking to give you car a modern sequential turn signal look.....

THE GOOD- It works in my '02 Mustang GT!- It's a simple product.- The black rubberized "potting" material protects the important parts from water as it runs down the trunk channel and drops down behind the tail light housing (this is how water is supposed to travel).- The wires are perfect length, with a couple inches to spare.- Instructions with color photos on the web.- The new blue wire for the inner "drone" bulb fit the bulb housing well.- The price is just right. I probably wouldn't have paid much more, but I'm satisfied with what I got and the result.THE BAD- No instructions in the box.- Web photos are all stretched or squished. Better if you save each one to disk and then open locally.- You technically render your car illegal to drive until we finish the job, so don't start until you have everything you need.- I dislike crimp-on connectors with a passion. They were the source of one of my issues. And there are no spares in the box.THE UGLY- Cutting your vehicle's tail light wires is a bit nerve-wracking if you don't do this kind of thing often... plus they are already short, so there is not a lot to work with.- If you don't plan well, you will do something wrong and something will not work. I planned well and still had a couple of stumbles.- Disconnecting the battery to do the splicing and then re-connecting it to start the car for test gets a little tedious if you are not perfect on your first test.- When you install the new blue wire's pin into the drone bulb's housing, you really have to seat it deeply. This was one of the issues I had to debug.SUGGESTIONS- Study every photo and the steps.- Understand how this kit works before you start... you'll need to understand it if something doesn't work first try.- Buy 6 new dual filament bulbs and 2 new backup bulbs before you start. It's easy to swap them all while the housing is loose.- Install and test one side at a time.- Buy the slow flasher unit. It makes it look right, since the normal flasher is just too fast for sequential to look good.4 stars!

Purchased these and when I installed them inner most bulb on both aides does not turn on at all middle and outer flash fine.. contacted seller to see if the warranty applies and if I can get a working module .. also probably doesn't work because 1 blue wire is missing from both modules

The media could not be loaded. Don't screw up they only give the exact amount of butt splices. But install was easy using wiring diagram and turned out awesome couldn't be happier. Also went with the flasher relay and the result is awesome.

Works as it is suppose to. Instructions straight forward. A nice addition to my 94 mustang with 96 tail lights.Tried cheaper knock offs . Did notwork as they said they would

Compared to other sequential tail light kits this one was much cheaper. I work in the automotive industry so the extra cutting and splicing of wires did not concern me. I removed my tail lights and the wiring harness to make installation easier. I installed one harness and reinstalled the light to test and had an odd flashing pattern and the third bulb, which is usually not functioning, still would not light up. I switched bulbs with new bulbs, tested redid all the wiring and continued to test. I eventually applied power to the dummy bulb directly and was able to get it to light. I rechecked my work one last time and still did not have proper functionality. I was disappointed after all the effort I wanted them to work. I ended up buying another product which is working great.

They work perfectly at a fraction of the cost of replacing the entire harness. I unplugged the harness and fed the thru the hole and brought it in the house to installed it on the tail light then brought it back out and plugged it in......much easier.