Walker 56194 Direct Fit Exhaust Resonator and Pipe Assembly for Honda CR-V

Perfect for 2006 crv

Mostly well made and fit well. All 4 of the joints were not welded the full circumference, thus leaking a lot of exhaust and noise. I was able to use it after fixing all the welds, reinstalled, and much more quiet with no more leaks. The price was good. Just may need to do some welding or live with the loud leaks.......Update: now that I've been driving it I still say it is good quality, but I do notice the resonator section is significantly smaller than the Honda factory original. It has different sound harmonics and therefore sounds different than the factory unit. More sound is audible with this unit. Not bad, just not as quiet as the factory resonator. If I were to do it over I would fabricate the end that bolts into the cat and weld it to the factory resonator, replacing the part that was cut off during the robbery of my original catalytic converter. But, if you don't want to do that, this unit works fine and is an acceptable bolt on part.

I got my catalytic converter stolen and ended up having to buy this part because they sawed off the place where it would connect. I’ve had it on for a little over two weeks and it’s quiet and runs good! And it was a perfect fit for my 2005 Honda CR-V

The oxygen sensors and catalytic converter was cut out before I purchased the 2006 Honda CRV and fit in just as it was a factory part and sounds quiet. Would highly recommend this part.

Exact fit installed easily with zero fit issues only hiccup for mw was no having a replacement gasket , however after having my catalytic convertor stolen the oem resonator was sawed leaving about 6 inches missing between aftermarket replacement cat, i happened to peak at a similar cr-v while i was out and saw this was exact oem fit i highly recommened if your exhaust is in similar situation overall very pleased just be sure to buy another exhuast gasket mine was as old as the vehicle and was just crumbs upon removal however i can already see and feel improvment on the vehicles gas mileage its returning to the condition prior to having my exhaust stolen

2004 CRV w/ stolen cat. This is not as nice as OEM, but saved a lot. Had to bend the rear hanger to fit. Easy to do with a piece of pipe or tubing. All else fit perfect. Would by again. Hard part was finding cheap O2 sensors that work.

Perfect fit

Fit is good. May need slight bending of hanger hooks. This is normal to all brands. Have used Walker for many years and quality is as good/better than any aftermarket. OE is usually the best but the price will break your legs. Doesn't include gaskets (flat in front, cone donut at rear) so order ahead of time or, better yet, get them locally. Gaskets really should be sold together with the pipe/resonator. The Walker gaskets from my parts store were different from the original but worked fine. Use penetrating oil on rubber hangers to ease removal. Discard any rusted nuts and apply anti-seize to threads for future happiness.

It fit on the CRV pretty good. Have no complaints hear.

The welds are horrible, and you need to adjust the rear Hanger to fit in the rubber. Other than that, it works.