Armour Products Etch Over N Over Stencil with 1.5-Inch Letters, 3 Sheets

Bought these to etch gallon marks on carboys (glass water jugs). It worked. Make sure the glass is clean. I rinsed the carboy first and then went over the areas where I was going to etch with 91% rubbing alcohol. No issues with them coming off. One other thing I would recommend is to use masking tape around the outer edges. This will help if you get a little sloppy with your brush.

The quality seems good. It was larger than expected, so I wasn’t able to use them.

We used these to personalize glass water bottles for family as a gift and they work well together with Armour Etch. However in order to do your etching in one pass you will need at least 2 sets if you have any names that repeat a letter otherwise you will be partially etching the name, waiting for the process to take place and then having to come back and place the repeated letter in the remaining spot. We found it easier to just place the letters from the start.

I used these to etch water volume marks on my brew kettles.They worked great on both straight sided pots, as well as on my keggles.This cuts down brew day time having to measure 1 gallon of water at a time.Just 1 note: they won't stick very well unless the vessel is completely dry. I ended up using a pencil to mark my volume levels, then emptied the pot/keg and dried it out. the pencil mark will remain. I then used the 'dash' stencil for my water level mark, and the corresponding # for the volume. I was able to mark 3 vessels and these things probably could handle another 10 and still work wonderfully.

I like these. My dislike is how flimsy they are. But I can still use them.

Letters only 1 inch - heading misleading since they said 1.5 inch

Bought these since the first review I saw was how they worked well when etching a brewpot. Since we were also etching a brewpot it just seemed right. The numbers held up great to the vinegar/salt solution and we were able to move them multiple times and they still stuck well. Now we can tell our pre and post boil volumes which should help us reach our intended kegging capacity and be more consistant.

These letters are nicer than I thought. Thank you

Worked perfectly to add volume marks to the inside and outside of my 16 gallon brew kettle. Re-usable and I plan on using them to etch the glass carboys too.

Not as I expected. I thought these were a plastic traceable stencil bu are actually paper thin.

Arrived in plenty of time to complete my projects before the holidays. Works great!