USlansis White iPhone 7 Plus Screen Replacement 3D Touch Screen Glass Digitizer Frame Assembly Set with Tempered Glass Screen Protector + Repair Tools + (iPhone 7 Plus white1-51)

For the price this harness is perfectly suited for hooking up a pair of led lights across the front or back of a vehicle. i ran 2 of these harnesses for 2 set of lights up front on my 1995 wrangler and it was great. i got switch power and ground from inside the cab so only the 2 relay trigger wires went through the firewall which required a nice small hole with a rubber grommet. switches were a 3/4 inch hole and i notched them for the alignment tab with a dremel so they couldn't spin around. i also switched out the leads to the led's to a 2 pin waterproof connector per light. (my preference). as per others comments about cheap connectors used in the kit. if you want better connections buy a more expensive kit, but the connectors they chose are more than adequate for the application even to a novice wiring person.

This thing almost burned my car to the ground. I'm no wiring expert but I can follow directions. I setup the wiring prior to installing my light bar (initial test worked great) and went to test it again after a few months and it wasn't working. I remembered messing with the switch at one point because it was in the way, so figured I accidentally switched some wires around. I began trying different combinations with the three wires going to the switch. Normally I wouldn't have done this but this product is FUSED so it should have popped if it caused a problem. NOPE. At one point I obviously touched power to ground and ground to power. The wire overheated, burned through the insulation all the way from the battery, through the fire wall and under my dash. Yes this is technically my fault for touching wires incorrectly (why I'm rating it 2 stars not 1), but I didn't have the directions with me at that moment so I figured I could just put a new fuse in if I did it wrong.Regardless of whether or not I installed it correctly, the fuse should have prevented this problem.Now I have to inspect tons of wires for damage and repair as necessary. Not something I wanted to do over my break.Advice: Use your head, go to an auto parts store and buy the components yourself.

This is a great relay control wiring system. The only complaint I have is the power feed circuits need to be much longer. I had to add wire to both the positive and negative feed circuits. Note I am using this control relay on my ATV's additional LED light bars. Outside of that issue the design is great. The feed circuits are ready to accommodate almost any devices. I would recommend this product and do plan on using again.

A great product. Bought a diffrent one first. Different as in type brand and all. It fired a wire an almost caught my truck on fire. Bought this off a friend's recommendation an can't be happier so easy to use an wire up. Works flawlessly. Great buy for sure!

Well put together. Really made for two lights that will not be far from each other. If you are going to put one connector at each end of a car, you will need to do some splicing, but other than that exactly as advertised.

Great way to learn how to wire up your own relay with this harness. Only down was that they didn't use copper wire through out the whole harness and maybe a little bit thicker gauge wire

Finished installing the light bar and wiring harness yesterday. Have not yet used the UTV at night to see how well the light works. Hope to try it this weekend.

Very easy kit to install - if you have no experience with vehicle wiring this is the kit for you. Those of us with experience you will find that you might want to modify the wiring a little to make clean runs from the switch to further lights but very simple